#AIRBRIDGE WIRELESS GUITAR SYSTEM HOW TO#
#AIRBRIDGE WIRELESS GUITAR SYSTEM INSTALL#

We recommend that you log in to the local browser UI of the master first. You can change the management mode so that you can use NETGEAR Insight to manage the configuration for a point-to-point setup between a master and a satellite. Note: By default, the management mode of the preconfigured AirBridges is local browser UI. Optional: Log in to the master and satellite Connect a WiFi access point to the LAN port on the satellite’s power adapter and then connect a WiFi client to the access point.Īt the detached site, if you can access the network at the main site and the Internet, the WiFi connection functions.ĥ.Connect a computer to the LAN2 port on the satellite.Test the network connectivity by doing one of the following: Note: You can use the NETGEAR Insight app to align the satellite. Make sure that the front panel of the satellite is facing the front panel of the master at the main site.Make sure that the satellite is in a direct, or near line of sight to the master at the main site.Place the satellite at a higher location.If the signal strength is weak or moderately good, make sure that you place the satellite according to the following guidelines: Use the SSI LEDs to adjust the position of the satellite for an optimal WiFi signal. After the satellite establishes a WiFi connection with the master, the signal strength indicator (SSI) LEDs light to indicate the strength of the signal for the WiFiģ. Connect power to the satellite the same way you did for the master (see 2.You can place the satellite at a distance of 1.8 miles (3 km) or more from the master.

#AIRBRIDGE WIRELESS GUITAR SYSTEM INSTALL#

Install the AirBridge satellite at the detached location in such a way that the satellite is in a direct line of sight to the master at the main site, and is facing the master.Install the master to allow for a direct line of site to the detached location, facing the location where you want to install the AirBridge satellite.Slide the bottom port cover onto the master until it latches.(Do not connect the LAN2 port on the master directly to your network.) Connect the LAN port on the power adapter to a LAN port on a switch or router on your network.If the network includes a DHCP server, such as a router, the master is automatically assigned a new IP address. We recommend that you connect the AirBridge master to a network with Internet access during setup. Connect the AirBridge master to the network Using any other power source can damage the device.Īll the LEDs light and then go off. WARNING: Power on the AirBridge only with an Ethernet cable connected to the provided power adapter, which must be placed indoors.

Connect the other end of the cable to the PoE port on the power adapter. With the back of the AirBridge facing you, connect an RJ-45 Ethernet cable (not provided) to the AirBridge 24V PoE port on the right side of the device.Pull down on the latch on the front of the device and remove the bottom panel of the AirBridge to expose the ports.This point-to-point setup requires a line of sight between the AirBridge master at the main site and the AirBridge satellite at the detached site. You connect the AirBridge master to your wired network at the main site to provide WiFi connectivity to the AirBridge satellite that you install at the detached site. One AirBridge device is preconfigured as the master, the other one as the satellite.

#AIRBRIDGE WIRELESS GUITAR SYSTEM HOW TO#

This installation guide describes how to establish a WiFi bridge between two Insight Instant Wireless AirBridge devices that are preconfigured for a point-to-point setup. Please see Device’s Terms and Conditions for more details. Vendor or Reseller or Distributor is not responsible for illegal wireless operations. It is the installer’s responsibility to follow local country regulations including operations within legal frequency channels, output power and DFS requirements. This device must be professionally installed.

Airbridge wireless guitar system